Zeiss S100, Instructions For Use Manual

Page: 131 / 278

Version 9.0
G-30-1781-en
Page 131
S100 / OPMI pico Operation

The main and backup lamp are intact in the halogen light source.

Main and backup lamp are intact in the xenon light source.
If the maximum service life of 500 hours of the ,main lamp has been
exceeded and the replacement lamp is being used, you should have
a replacement lamp module available for replacement purposes as
a precaution (see Page 226). For the order number, please see the
chapter "Device data".

With the LED light source, the amber LED is not illuminated.

It is possible to switch on or off the halogen, xenon or LED light source
by moving up and down the suspension arm.
The light source is turned on within the preset working area.
The light source is turned off in the upper resting position of the
suspension arm.
WARNING Function deterioration of the light source
With increasing service life of the light source, the actual light intensity
decreases (this is a normal system property).
• Before every use, ensure that the available light quantity is sufficient.
• Have a backup light source (e.g. surgical lamp) available.
For halogen light source:
•
If necessary, exchange the lamp (seePage 224).
After changing the lamp, check the brightness setting.
For xenon light source:
•
Switch to the backup lamp.
If you are already working with the backup lamp, be sure to replace the
slide-in lamp module (see Page 226). Check the set brightness after the
lamp exchange.
WARNING Precautions in case of device failure
• We recommend you to take adequate precautions, depending on the
application, to enable the surgical procedure or treatment to be finished
without using this microscope, if required.