Zeiss 000000-1080-349, Instructions For Use Manual

Page: 106 / 278

Preparations for use S100 / OPMI pico
Version 7.0
Page 106 G-30-1781-en
Relocating the S100 floor stand
Please observe the following points when relocating the suspension system:
• Turn off the device at the power switch.
• Remove the power plug from the wall socket.
• Disconnect the video cable between the video modules (e.g. video moni-
tor, video recorder) and the camera control unit (CCU).
• Adjust the flat screen (optional) to a secure transport position.
• Do not transport the device by pulling or pushing on the optional flat
screen!
• Avoid any uncontrolled swiveling of the optional flat screen.
• Swing the suspension arm into the transport position.
• Unlock all arrestors of the casters.
• Hold the system by the marked position on the stand column and carefully
push it along. Make sure that the system is positioned on level ground.
• Press at least two of the arrestors and make sure that the suspension sys-
tem is no longer able to roll away by itself.
The mass may be underestimated as the suspension system can be smoothly
moved. Therefore, move the suspension system slowly and carefully!
CAUTION Risk of crushing and toppling during transportation of the system!
If the following precautions are not observed, the floor stand may topple
over and injure persons!
• Move the floor stand into its transport position.
• To safely move the system, always hold the stand column at the position
marked with a label.
CAUTION Risk of crushing - mind your fingers!
Fingers may be crushed in the areas marked with the "Risk of crushing" label.
• Do not touch these areas while the system is being moved or brought
into its working / transport position.