YOKOGAWA ScopeCorder DL750P, Operation Manual

Page: 48 / 61

IM 701210-07E
47
CURSOR
Cursor type
Section 11.5
Select from H cursor, V cursor, H&V cursor,
marker cursor, and angle cursor.
Target waveform
Select the target waveform for cursor
measurement.
Move the cursor
Set the position of the two vertical cursor.
Cursor jump
Select the type of jump when jumping the
cursor.
Execute cursor jump
Cursor Types
• H (Horizontal) cursors
Two broken lines (H cursors) are displayed on the X-
axis (horizontal axis). The voltage of each H cursor
and the voltage difference between the H cursors are
measured.
• V (Vertical) cursors
Two broken lines (V cursors) are displayed on the Y-
axis (vertical axis). The time from the trigger position
to each V cursor and the time difference between the
V cursors are measured. The voltage value of the
signal at each cursor position, and the voltage
difference between the cursors are also measured.
• H&V cursors
H cursors and V cursors are displayed simultaneously.
• Marker cursors
Four markers are displayed on the specified
waveform. The voltage and the time from the trigger
position of each marker as well as the voltage
difference and time difference between markers are
measured.
• Angle (Degree) cursor
Measures the angle between two angle cursors with
respect to a reference angle corresponding to the
width between the zero point and the end point,
which are measurement references.
Note
• The following figure shows the menu that appears when the cursor type is set to V cursor.
Cursor type
Section 11.5
Select from H cursor, V cursor, H&V cursor,
marker cursor, and angle cursor.
Select the marker
Select the marker to be moved.
Target waveform
Select the target waveform for cursor
measurement.
Move the marker
Set the marker position. The icon of the target
marker appears in the top right section.
Jump the marker
Select the type of jump when jumping the
marker.
Execute the marker jump
• The following figure shows the menu that appears when the cursor
type is set to marker cursor.