YOKOGAWA DTSXL, User Manual, Page: 91 / 289

< PART – B Software >
B-8
IM 39J06B40-01EN 14th Edition: May 30, 2022
SEE ALSO
For details on how to use the DTSX3000 Control Visualization Software (DTAP3000) and Data
Conversion Software, read their respective user manuals.
- DTAP3000 DTSX3000 Control Visualization Software Guide (IM 39J02B40-01EN)
- DTAP3000D Data Conversion Software WITSML1.3.1.1 Guide (IM 39J02B40-03EN)
TIP
The Web browser and software for DTSX3000 can be installed and used on the same PC.
B1.4. IP Address Configuration
The first IP address of the DTSX3000 is set to 192.168.1.10 in the factory before the
shipment. The IP address can be configured from a Web browser as needed.
This section explains how to perform setup for IP address configuration for the
DTSX3000 when the previously configured address is unknown or forgotten.
You need to enter a MAC address, which is unique to each device, in IP address
configuration. Write down the MAC address of the DTSX3000, which can be found on
the product nameplate pasted on the side of the DTSX3000.
Figure Location of Nameplate and MAC Address
TIP
- An optical switch, when installed, will block the nameplate. Write down the MAC address before
installing an optical switch.
The procedure for IP address configuration is described below.
 Install the IP Address Configuration Tool on a PC.
Install the IP Address Configuration Tool on a PC if it is not already installed using the
following procedure.
Location of the nameplate
MAC address