YOKOGAWA DTSXL, User Manual, Page: 275 / 289

< PART – C Operation and Maintenance >
C-22
IM 39J06B40-01EN 14th Edition: May 30, 2022
5. In reverse order of the above steps, install the new battery.
The figure below shows how the battery connector should be inserted.
When inserting the connector, the connector lever should be facing left.
Figure Attaching the Connector
6. Perform the following steps in accordance with the replacement procedure of the
DTSX3000.
- Install the DTSX3000 to the Base module.
- Connect the sensor optical fiber and the control network cable to the DTSX3000.
- Turn on the power.
7. When the HRDY LED indicator starts blinking after power on, press the RESET
switch.
- When you press the RESET switch, the module boots up in Maintenance mode
with blinking HRDY and RDY LED indicators.
8. Display the DTSX3000 maintenance menu from a Web browser running on a PC,
and set the system date and time.
9. From the reboot menu in the Web browser, boot up the DTSX3000 in online state.
SEE ALSO
For details on date and time configuration, see Subsection B6.4.5, “Date and Time Configuration
(Date).”
TIP
If the battery of the DTSX3000 is totally discharged, resulting in a power failure, the IP address,
DTSX3000 total power-on time and other information will be lost and the DTSX3000 will restart in the
state prevailing at the time of the last shutdown.
To avoid such risks, replace the battery regularly.
Main body
side
Connector from
battery
(1) Before insertion 2) During insertion (3) After insertion