YOKOGAWA DTSXL, User Manual, Page: 162 / 289

< PART – B Software >
B-79
IM 39J06B40-01EN 14th Edition: May 30, 2022
- Sequence Mode
If [Single] is selected, the sequence defined in Subsection B7.2.1, “Sequence Table
Settings” is executed once, after which measurement stops. If [Continuous] is
selected, the sequence defined in sequence table settings is executed repeatedly
until a stop measurement command is received.
If [Continuous] is selected, the sequence is executed repeatedly according to the
Repetition Mode settings.
- Repetition Mode
Specify the repetition mode for repeating the execution of the sequence table when
[Continuous] is selected for [Sequence Mode]. For repetition mode, select either
[Sequence Interval] and specify the interval between two start times in the sequence
table, or [Sequence Start Time] and specify the start times table.
If [Sequence Interval] is selected, specify [Interval] (the interval between two start
times in the sequence table) as a value from 0 seconds to 86400 seconds in units of
1 second.
The sample settings shown in the preceding screen capture defines the following
sequence execution:
If the execution time for measurement is longer than the specified measurement
interval, the next measurement begins immediately after the current measurement
ends.
If [Sequence Start Time] is selected, measurement starts from the first line of the
sequence table at the specified starting times. Up to 6 start times in hhmmss format
(24-hour time representation) can be specified in the [Start Time Table].
If [Start Time Setting] is specified as [Every Day], measurement starts from the first
line of the sequence table at the times specified in the [Start Time Table] every day.
If [Start Time Setting] is specified as [1 Cycle], measurement is executed at the start
times specified in the [Start Time Table] once, after which measurement stops.
[sec]
Interval=1000[sec]
1st sequence
execution
Interval=1000[sec]
2nd sequence
execution
3rd sequence
execution