FUEL SYSTEM
6-20
6LPA Service Manual
Fuel Injection Nozzle
© 2007 Yanmar Marine International
7. Install the tip packing and straight pins into the
special tool as shown (Figure 6-28).
Figure 6-28
Figure 6-28
1 – Special Tool
2 – Top
3 – Bottom
8. Adjust the dial indicator reading to zero on the
special tool or square block, using the special
tool (Figure 6-29, (1)).
9. Install the straight pins into the tip packing and
then into the holes in the special tool
(Figure 6-29, (1)) and then measure dimension
(L2).
Figure 6-29
Figure 6-29
10. Measure dimension (L3) (Figure 6-30) of the
adjusting shim, using a micrometer. If the
measured needle lift is out of the specified
range, change the adjusting shim. NOTICE:
Increasing the shim thickness reduces the
needle lift.
• Needle lift = (L1+L2) - L3
• Needle lift: 0.26 to 0.31 mm (0.0102 to
0.0122 in.)
Figure 6-30
Figure 6-30
(1)
(2)
(
3
)
00052
88
(1)
(1)
(1)
(L2)
00052
8
9
(L
3
)
0005290