4 - 23
ENG
CYLINDER HEADS
d. Place a 400 ~ 600 grit wet sandpaper on
the surface plate and resurface the cylinder
head using a figure-eight sanding pattern.
NOTE:
@
To ensure an even surface, rotate the cylinder
head several times.
@
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS00233
INSTALLING THE CYLINDER HEAD
1. Install:
• timing chain dampers
1
2. Install:
• dowel pins
2
• gasket
3
NOTE:
@
The “HEAD” mark
a
on the gasket must face
up.
@
3. Install:
• cylinder head
1
NOTE:
@
Pass the timing chain
2
through the timing
chain cavity.
@
4. Tighten:
• cylinder head nuts
NOTE:
@
• Lubricate the cylinder head nuts with engine
oil.
• Tighten the cylinder head nuts in the proper
tightening sequence as shown and torque
them in two stages.
@
5. Install:
• exhaust camshaft
• intake camshaft
Refer to “INSTALLING THE CAMSHAFTS”.
New
T
R
.
.
43 Nm (4.3 m · kg)
Summary of Contents for VMX12 2001
