4 - 18
ENG
CAMSHAFTS
5. Check:
• TDC mark
a
Make sure the TDC mark on the generator
rotor is aligned with the stationary pointer
b
.
• camshaft timing punch mark
c
(o: small
hole)
Make sure the punch marks in the cam-
shafts are aligned with the marks
d
on the
camshaft caps.
Out of alignment
→
Adjust.
Refer to the camshaft installation steps
above.
6. Tighten:
• camshaft sprocket bolts
CAUTION:
@
Be sure to tighten the camshaft sprocket
bolts to the specified torque to avoid the
possibility of the bolts coming loose and
damaging the engine.
@
7. Install:
• camshaft caps “I-2”
1
• camshaft caps “E-2”
2
• timing chain guide (top side)
3
• timing chain guide (exhaust side)
4
8. Lubricate:
• timing chain
• camshaft sprockets
• camshafts
• valve pads
Recommended lubricant
Engine oil
T
R
.
.
24 Nm (2.4 m · kg)
T
R
.
.
10 Nm (1.0 m · kg)
Front cylinder
NOTE:
@
When installing the front cylinder camshafts,
repeat the rear cylinder camshaft installation
procedure. However, note the following points.
@
Summary of Contents for VMX12 2001
