![background image](http://html.mh-extra.com/html/yamaha/motif-rack-es/motif-rack-es_owners-manual_902713067.webp)
Owner’s Manual
Utility
V
oice mode
P
erf
or
mance mode
Multi mode
Eff
ect
Ar
peggio
Ref
erence
Voice mode Voice Edit (for Normal Voice)
67
KeyReset
Key On Reset
Determines whether or not the LFO is reset each time a Note On message is received. The following three
settings are available.
Settings:
off, each-on, 1st-on
off..................... The LFO cycles freely with no note synchronization. Receiving a Note On message starts the LFO wave at
whatever phase the LFO happens to be at that point.
each-on ........... The LFO resets with each Note On message and starts a waveform at the phase specified by the Phase
parameter (below).
1st-on .............. The LFO resets with every note you play and starts the waveform at the phase specified by the Phase
parameter (below). However, if you play a second note while the first is being held, the LFO continues cycling
according to the same phase as triggered by the first note. In other words, the LFO only resets if the first note
is released before the second is played.
Phase
Phase
Determines the starting phase point
for the LFO Wave when it is reset.
Settings:
0, 90, 120, 180, 240, 270
Delay
Delay
Determines the delay time between the moment that a Note On message is received and the moment the
LFO comes into effect. A higher value means a longer delay time.
Settings:
0 ~ 127
FadeIn
Fade In
Determines the amount of time for the LFO effect to fade in (after the Delay time has elapsed). A higher
value means a slower fade-in.
Settings:
0 ~ 127
Hold
Hold
Determines the length of time during
which the LFO is held at its
maximum level. A higher value
means a longer Hold time. When
sets to “127,” the wave cannot be
faded out (below).
Settings:
0 ~ 127
FadeOut
Fade Out
Determines the time taken for the LFO effect to be faded out (after the Hold time has elapsed). A higher
value means a slower fade-out.
Settings:
0 ~ 127
Dest1-3ElmSw
LFO Destination Element
Switch
Determines whether to allow variations in the LFO Wave for each Element. The Element number (1- 4) is
shown when the LFO is enabled; a dash (-) indicates the LFO is disabled for that Element.
Dest1-3Dest
LFO Destination
Determines the parameters which will be controlled.
Settings:
amd, pmd, fmd, reso (resonance), pan, ELFOSpd (Element LFO Speed)
Dest1-3Depth
LFO Depth
Determines the LFO Wave Depth.
Settings:
0 ~ 127
Note On
Note On
(first note)
Note On
(second note)
Note On
(first note)
Note On
(second note)
Time
Time
Time
off
each-on
1st-on
0
°
90
°
120
°
240
°
180
°
270
°
Phase
Time
Low Fade In value
(faster fade-in)
Note On
Note On
High Fade In value
(slower fade-in)
Time
Time
Max
Max
Delay
Delay
Fade In
Fade In
Time
Max
Hold
Low Fade Out value
(faster fade-out)
High Fade Out value
(slower fade-out)
Time
Time
Max
Max
Fade Out
Fade Out
Hold
Hold