96
Genos Reference Manual
Punch In/Out Recording—Replace or Overdub a Certain Range of the
Data
This method of recording can only be used on an existing recording. It allows you to re-record over a specific part of
the already-recorded material. You can replace the original part with the new recording by Punch In/Out recording, or
keeping the original and mixing it with the new by Punch In/Out recording with the overdub enabled. This lets you
either correct a mistake in the recording or overdub new parts onto the original recording.
Keep in mind that sections before and after the Punch In/Out section of the track are not recorded over and remain as
the original data—but they play back normally to guide you in and out of the recording.
1
To select the desired file, execute Steps 1–3 in “Selecting a Multi Track Audio File (.aud)”
on
2
Select the desired track to be re-recorded, by touching [Rec] corresponding to the track.
3
Set the recording mode.
3-1
Set the parameter “Rec Mode”.
Select the desired Punch In/Out mode, according to how you want to trigger recording.
•
Manual Punch In/Out:
This lets you manually execute Punch In/Out recording by operating on the dis-
play.
•
Pedal Punch In/Out:
This lets you manually execute Punch In/Out recording by using a connected foot-
switch to the ASSIGNABLE FOOT PEDAL 2 jack.
•
Auto Punch In/Out:
This lets you automate Punch In/Out recording, by specifying the recording range in
advance (see below).
3-2
Set the “Overdub” checkbox off/on.
•
Off:
Replace a certain range of the data on the track.
•
On:
Mix the new recording to the existing data in a certain range on the track.
When you re-recording the file by Punch In/Out method, we recommend re-recording only one range at one time. This is because the Undo/Redo function can undo/redo
only one range that was recorded immediately before.
NOTE
Original Data
Original Data
Re-recorded Data
Start Recording
Punch In
Punch Out
Stop Recording
NEXT PAGE
