Yamaha CS1D, Owner'S Manual

Page: 93 / 617

CS1D Operating Manual (Basic Operation)
34
Basic operation INPUT blocks/ST IN block
This section explains basic input channel operation using the INPUT blocks/ST IN block.
Since multiple channels are controlled simultaneously in the INPUT blocks/ST IN block, the number of controlla-
ble parameters is limited to the necessary minimum. This means that there are some parameters that cannot be con-
trolled unless you use the display or the SELECTED INPUT CHANNEL block.
INPUT block/ST IN block controls and functions
This section explains the various controls and functions of the INPUT block and ST IN block.
INPUT block
MIX
ON
10 0
PAN
TO ST
CLIP
R
+48V
INPUT
INS A
B
L
GAIN
DCA
-68
+
THR
-
COMP
+
THR
-
CLIP
6
12
18
2
3
1
4
6
7
5
8
10
11
9
12
30
60
GATE
+10
10
5
5
0
10
ON
SEL
INPUT [MIX] encoder and LEDs
This encoder sets the send level of the signal that is
sent from the input channel to a VARI type MIX bus.
The peripheral LEDs will light to indicate the approxi-
mate current value.
INPUT MIX [ON] LED
This LED indicates the on/off status of the signal that
is sent from the input channel to the MIX bus.
INPUT [PAN] encoder and LEDs
This encoder sets the stereo position of the signal that is
sent from the input channel to the STEREO bus. The
approximate current value is shown by the perimeter LEDs.
INPUT [TO ST] switch and LED
This is an on/off switch for the signal that is sent from
that input channel to the STEREO bus.
INPUT [GAIN] encoder and LEDs
This encoder adjusts the input sensitivity of the head
amp for an input channel to which a mic/line input card
(LMY2-ML) has been patched. The peripheral LEDs
will light to indicate the approximate current value.
INPUT [CLIP] LED
This LED will light when the input signal clips for that
input channel.
INPUT [+48V]/[INS]/[ø] LEDs
These respectively indicate the on/off status of
phantom power, insertion, and phase.
INPUT [A]/[B] LEDs
For an input channel to which a mic/line input card
(LMY2-ML) has been patched, these indicate
whether input jack A or B is enabled.
COMP [+]/[THR]/[–] LEDs
These LEDs show the operating status of the inter-
nal compressor. For details on the meaning of each
LED, refer to “CS1D Reference Manual (Software).”
GATE [+]/[THR]/[–] LEDs
These LEDs show the operating status of the inter-
nal noise gate. For details on the meaning of each
LED, refer to “CS1D Reference Manual (Software).”
INPUT [NAME] indicator
This shows the short name of the input channel.
Meter LEDs
This is a six-point LED meter that indicates the
input level of the input channel.
INPUT [SEL] switch and LED
This switch selects the input channel that will be con-
trolled in the SELECTED INPUT CHANNEL block and
in the display.
INPUT [ON] switch and LED
This turns the input channel on/off. If this switch is
turned off, no signal will be sent from this input chan-
nel to the STEREO bus or MIX buses.
INPUT fader
This is a 100 mm fader that adjusts the input level
of the input channel.