Yamaha CS1D, Owner'S Manual

Page: 16 / 617

CS1D Operating Manual (Start-up)
8
Connecting an analog input/output unit to the engine (Stan-
dard mode)
The following diagram shows a common way of making connections between the engine and analog input/output units
for Standard mode.
1 Analog input unit AI8 connection
Connect the OUTPUT A connector of the AI8 analog
input unit to one of the INPUT 1–INPUT 10 con-
nectors of the engine. Set the CONTROL PORT
switch (located on the rear panel of the AI8) to the A
position.
2 Analog output unit AO8 connection
Connect the INPUT A connector of the AO8 analog
output unit to one of the OUTPUT 1–OUTPUT 6
connectors of the engine. Set the INPUT SELECTOR
switch (located on the front panel of the AO8) to the
A position.
Hint
An AI8 analog input unit can be connected to any
INPUT connector of the engine, and the number of
that INPUT connector will be the ID number of that
unit. Similarly, an AO8 analog output unit can be
connected to any OUTPUT connector of the engine,
and the number of that OUTPUT connector will be
the ID number of that unit.
Be careful not to connect inputs and outputs in
reverse. If such a connection is made, the unit will
not be recognized and cannot be controlled.
ANALOG OUTPUT BOX ANALOG OUTPUT BOX ANALOG INPUT BOX ANALOG INPUT BOX
INPUT 1
INPUT 2
INPUT A INPUT A OUTPUT A OUTPUT A
OUTPUT 1
OUTPUT 2
1 2
ENGINE A
(DSP1D-EX{DSP1D})
AI8 (ID=2) AI8 (ID=1) AO8 (ID=1) AO8 (ID=2)
CONTROL PORT
Switch = A INPUT SELECTOR
Switch = A CONTROL PORT
Switch = A
INPUT SELECTOR
Switch = A