Yamaha 2001 YZ426F/LC, Owner'S Service Manual

Page: 130 / 626

2 - 21
SPEC
CABLE ROUTING DIAGRAM
EC240000
CABLE ROUTING DIAGRAM
1 Hose guide
2 Brake hose
3 Fuel tank breather hose
4 Oil tank breather hose
5 Clamp
6 “ENGINE STOP” button lead
7 Sub wire harness
8 TPS (throttle position
sensor) lead
9 Neutral switch lead
0 Oil hose
A Hose holder
B CDI magneto lead
C Clutch cable
D Cylinder head breather hose
E Carburetor breather hose
F Overflow hose
Å
Pass the clutch cable through
the cable guide.
ı
Pass the fuel tank breather hose
between the handlebar and ten-
sion bar, then insert its end into
the hole of the number plate.
Ç
Pass the decompression cable
and “ENGINE STOP” button
lead under the frame.
Î
Fasten the CDI magneto lead,
neutral switch lead and
“ENGINE STOP” button lead to
the frame with a plastic locking
tie and cut off the tie end.
‰
Pass the “ENGINE STOP” but-
ton lead along the inner side of
the oil tank breather hose.
Ï
Fasten the sub wire harness
and “ENGINE STOP” button
lead to the frame in front of the
protector of the sub wire har-
ness with a plastic locking tie
and cut off the tie end.
Ì
Pass the cylinder head breather
hose along the right side of the
oil tank breather hose.
Ó
Pass the sub wire harness
between the engine brackets.
È
Fasten the sub wire harness
and “ENGINE STOP” button
lead to the frame at the rear of
the protector of the sub wire har-
ness with a plastic locking tie
and cut off the tie end.