78
WIRES-X Software
Main Menu
●
HRI-200 setup
CH.1
Allows you to set the analog circuit operations of CH1 (voice channel).
Normally, changes are not required for the default values.
Cautions
• When operating a HRI-200 control mode compatible transceiver (such as FTM-400DR), to ensure proper operation, be sure not to
change the default settings.
• With some FM analog transceivers, the settings may need to be changed.
SQL Active ..................................Set the SQL input jack logic. Normally, set it to High (default setting).
High .... High with signals/Low without signals (default setting)
Low ..... Low with signals/High without signals
After starting the WIRES-X software — in case when the “LOCAL” status indicator turns light
blue, while the squelch of the connected transceiver is closed — change this setting so that
the “LOCAL” turns gray.
RXin Select .................................Select the received audio input circuit (RX12/RX96) for the RADIO 1 jack of HRI-200.
Normally, set it to RX12 (default setting).
Caution
When operating as a digital station, RX96 must not be selected for a proper operation.
RX12 Input ..................................Set the input sensitivity of the RX12 received audio input circuit (Low/High). Normally, set it to
High (default setting).
Caution
Communications between digital stations are not affected by this setting.
RX96 Input ..................................Set the input sensitivity of the RX96 received audio input circuit (Low/High). Normally, set it to
High (default setting).
Caution
Communications between digital stations are not affected by this setting.
PTT Active ..................................Set the PTT output jack logic. Normally, set it to Low (default setting).
Low ..... Low: in transmitting status/High: in receiving status (default setting)
High .... High: in transmitting status/Low: in receiving status
After starting the WIRES-X software — in case when the “ON-AIR” status indicator turns
green, even while signals are not transmitted — change this setting so that the “ON-AIR” turns
gray.
TXout Gain .................................Set the signal level of transmitting audio output (TX12/TX96). Normally, set it to TX12 (default
setting).
Caution
Communications between digital stations are not affected by this setting.
De-emphasis ..............................Inserting a check-mark passes received sound into the de-emphasis circuit. Normally, keep
this function unchecked (default setting).
Caution
Communications between digital stations are not affected by this setting.
