OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
OS3007
Check output--dry ink may not be sticking to paper
The fuser may not be maintaining the temperature necessary for
dry ink to adhere to the paper. The following messages appear
on the printer control console display:
Check output. If acceptable, press Continue. If not call
senior operator.
Printer fault. Dry ink may not be adhering to paper. Press i
Action
Check the printed output. Then perform one of the following
actions:
•
If the output is acceptable, press <CON> or the Continue
button on the printer to resume printing.
•
If the output is degraded, contact your service representative.
OS3008
Transparencies loaded--print simplex to sample tray
Transparencies were loaded in the tray you selected. The JSL did
not specify simplex printing or delivery to the sample tray. The
job will not print. The message, Job cannot be printed. See
message at CRT, appears.
Action
1. Recode the JSL including the required specifications.
2. Restart the job.
OS3009
Remove top sheet in compiler tray. See printer message.
There is an extra sheet in the collection area of the
stitcher/stacker.
Action
1. Raise the sticker/stacker lid and remove the extra sheet from
the collection area.
2. Press <CON> to resume printing.
OS3010
Printer is warming up.
The printer is unable to respond to the command you entered
because the fuser cooled to below operating temperature, the
printer was in the power-saver mode, or the printer was just
powered on.
Action
Perform one of the following actions:
•
Wait for the fuser to reheat (the warm-up light on the system
controller turns off).
•
Wait until the message, Ready to print, appears on the printer
control console display.
9-68
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE