X-Rite 500 Series, Operator'S Manual

Page: 81 / 124

I N S T R U M E N T F U N C T I O N S
5-27
9.
Move highlight to re-measure any component, or
highlight
Save n
. The calculated value is displayed.
Press Enter key
#
to save.
NOTE: If an error message appears when
Save n
is highlighted, the
calculated value was out of range (.5 – 9.9) and cannot be used. Try
to re-measure.
Ref1, Ref2, and Ref3
Your instrument is preset at the factory to use the standard
tint percentages (25%, 50%, and 75%) for color bar patches
as the three dot gain measurement reference values.
NOTE : References are set to 40%, Off, and 80% when “Euro” is
selected as the User Configuration.
References are only used in dot gain mode with the
nFactor on or off. References are automatically selected
based on the tint of the last reading. When Dot Gain is on,
the instrument subtracts the nearest reference from the
Dot Area Reading and displays the result (difference from
Ref1, 2, or 3).
If needed, you can adjust the Reference values to meet
your specific needs.
To set reference values:
1.
With the Dot Options menu displayed, press the Tab Up
key
$
or Tab Down key
@
to highlight
Ref1
,
Ref2
, or
Ref3
. Press the Enter key
#
to
Ref#
menu.
2.
To adjust value, use the Tab keys
$@
to choose the
desired digit (arrows above and below designated
selection). Press the Enter key
#
to access the editor.
NOTE : Positioning the arrows above and below
+
or
–
and
pressing
the Enter key
#
toggles between the two symbols.
3.
Use the Tab keys
$@
to highlight the desired number
and press the Enter key
#
to exit the editor.
4.
To select On/Off status, press the Enter key
#
with
Off
or
On
highlighted.
5.
When editing is completed, use the Tab keys
$@
to
highlight
Save & Exit
and press Enter key
#
.