X-Rite 500 Series, Operator'S Manual

Page: 59 / 124

I N S T R U M E N T F U N C T I O N S
5-5
NOTE:
Reference
will not appear in the measurement list unless
DEN–REF01
is selected as the active density mode. Refer to Density
Measurement Mode earlier in this section.
R e f e r e n c e S e q
R e f 0 1
R e f 0 2
R e f 0 3
R e f 0 4
^
V 1.36
C 1.23
M 1.50
Y 1.65
<
M e a s u r e R e f
>
T
2.
Press the Tab Up key
$
to highlight the reference
measurement method (
Seq
or
Match
).
•
The Sequence (Seq) method automatically increments the
reference position as you measure. For example, when the
highlight is on
Ref 01
, and a measurement is taken, the
data is set for reference one and the highlight advances to
Ref 02
.
NOTE : When position 16 is reached, you must manually move the
highlight using the Tab keys
$@
if you want to restart the
measurement sequence before exiting.
•
The Match method is used to update an existing
reference. The measurement automatically replaces data
in the location that has the closest match to the
measurement.
3.
Press the Enter key
#
to alternate between
Seq
and
Match
.
4.
Center the target window over the first reference (or
replacement reference if a match), and lower the
instrument to take a reading.
5.
Continue with additional reference measurements.
To manually edit reference values:
1.
If not selected, press the Tab Up key
$
or Tab Down
key
@
to highlight
Reference
. Press the Enter key
#
to access the reference menu.
NOTE:
Reference
will not appear in the measurement list unless
DEN–REF1
is selected as the active density mode. Refer to Density
Measurement Mode earlier in this section.
2.
Use the Tab keys
$@
to move the highlight to the
desired reference location.
Reference
measurement method