X-Rite 500 Series, Operator'S Manual

Page: 42 / 124

C H A P T E R F O U R
4-12
Cal Alert
To set the calibration alert settings:
1.
Use the Tab keys
$@
to highlight
Cal Alert
.
2.
Press the Enter key
#
to access the
Cal Alert
menu.
3.
To enable or disable the calibration alert, use the Tab
keys
$@
to highlight the either
On
or
Off
mode. Press
the Enter key
#
to change modes.
4.
To set how often (in hours) the instrument will alert you
to perform a calibration, use the Tab keys
$@
to choose the
desired digit (arrows above and below designated
selection). Press the Enter key
#
to access the editor.
NOTE: Highlighting
Clear
and pressing the Enter key
#
is a quick
method to zero the value.
5.
Use the Tab keys
$@
to highlight the desired number
and press the Enter key
#
to exit the editor.
6.
When editing is completed, use the Tab keys
$@
to
highlight
Save & Exit
and press Enter key
#
.
Serial Port Options
The Serial Port configuration allows you to determine the
following settings:
•
Baud Rate – Choose the correct baud rate.
•
Hand Shake – Set the method of handshaking between
the instrument and your computer.
•
Auto XMT – Enabled with Status <00>, enabled without
Status, enabled without Status or attribute designation
(Spreadsheet), or disable automatic transmission of
measured data.
•
Separator – Determines the character that separates the
data components of a measurement.
C a l i b r a t i o n O p t i o n s
F u l l C a l i b r a t i o n
E n t e r R e f l e c t a n c e s
C a l A l e r t : 2 4 h r s
<
Select Options
>