Würth FKWS 9-125, Translation Of The Original Operating Instructions

Page: 20 / 266

20
Intended use
This device is only to be used as a grinder, sander,
for work with wire brushes and for cut-off machi -
ning of metal, concrete, stone and similar materials
without the use of water. Use only original Würth
accessories. Any other use or use outside this scope
is considered improper use.
The user alone is responsible for damage
resulting from improper use.
Technical Data
Art. 5707 000 X
Rated power consumption W 910
Power output W 430
No-load speed rpm 10,000
Grinding wheel dia., max. mm 125
Spindle thread M14
Length of grinding spindle mm 18
Min. attainable angle 43°
Speed at the rated load rpm 8,200
Maximum torque Nm 2
Rubbing disc / cut-off wheel:
Max. permissible thickness of the
attachment
mm 6
Max. permissible thickness of the
attachment in the clamping area
when using:
a) Two-hole nut
[7]
mm 6
b) Quick clamping nut [8] mm 8
Weight without mains lead kg 2.1
Protection class /II
Symbols on the name plate:
n = max. no-load speed
∼ = Alternating current
Noise /vibration information
WARNING !
The noise level may exceed 80 dB(A)
during work.
Â
Risk of severe injuries and acoustic
trauma.
¾
Wear ear protectors!
Noise emission values
These values enable the estimating of the noise
emissions of the power tool and comparison with
various power tools. Dependent on the conditions
of use, state of the power tool or attachments, the
actual loading may be greater or smaller. When
estimating also take into consideration work breaks
and phases with lower loading. Specify protective or
organisational measures for the user based on the
corresponding adjusted estimation values.
Art. 5707 000 X
a
h, SG
/K
h, SG
* m/s
2
5.5/1.5
a
h, DS
/K
h, DS
* m/s
2
< 2.5
L
pA
/K
pA
dB (A)
88/3
L
WA
/K
WA
dB (A)
99/3
Vibration total value (vector sum in three directions)
measured in accordance with EN 60745:
a
h
,
SG
= Vibration emission value (surface grinding)
a
h
,
DS
= Vibration emission value (grinding with grinding disc)
K
h, SG/DS
= Uncertainty (vibration)
Typical A-rated sound pressure level:
L
pA
= Sound pressure level
L
WA
= Sound power level
K
pA
,K
WA
= Uncertainty
* The specified vibration emission values:
• Were measured using a standardised test method
and can be used to compare one electric tool
with another.
• Can be used for a rough assessment of the
exposure.