Page 56
5.
Reset: The Reset button will reset the gathered loudness data. If it is
pressed while a loudness measurement is in progress, a new reading will
then immediately begin.
6.
Stop: When Manual Mode is selected in the
the Stop button will stop gathering loudness data. Data will be held for
viewing and not be reset using this control.
High Quality Audio System
The totally digital system architecture along with high-fidelity Class D amplifiers
provides loud, clear, low-noise, wide range audio monitoring. A standard ¼"
headphone jack is also provided.
Internal Router and Mixer
The wide variety of input and output possibilities offered by the AMP2-16V is a
product of the flexible internal digital audio routing system depicted in the diagram
in
As a factory default, the AMP2-16V will be configured to produce audio in the
speakers from the card in the monitor's lowest numbered occupied slot (typically
Slot 1). However, you can configure the monitor to produce audio in the front
speakers from any available input sources. Refer to the
section in Chapter 1 for details.
Note that you can set up multiple audio paths. For example, while monitoring de-
embedded SDI audio channels through the speakers, you may independently
decode Dolby channels from an AES stream, convert them to analog, and output
them. Setups like this can be stored as presets and called up at will.
Any monitored input can be routed to any AES or analog output pairs. These
powerful features will allow de-embedded, Dolby decoded, or other digital or analog
audio to be used by other products. The audio that is output doesn't necessarily
need to be monitored by the meters or speakers.
Input channels can be metered, rearranged, monitored, and output in any order, or
even mixed, panned, and trimmed. The resulting mixed output channels may also
be metered. Refer to
How do I Show Mixer Output Levels on the Level Meters?
in
Chapter 3 for details.
Because an optional redundant internal power supply is available, power integrity is
assured and the output of the internal mixer can be used for live events and
broadcast chain use. Refer to
How Do I Mix Any Input(s) to Any Output(s)?
