Page 135
19. Replace the lid and the screws.
Removing a Dolby D/E/DD+ Card
To remove a Dolby D/E/DD+ Card, follow the instructions in reverse for Adding a
Dolby D/E/DD+ Card but leave the standoffs attached to the system control board.
Note:
All presets will be set to a factory default appropriate for the new
arrangement of cards.
Adding an I/O Module
Adding a 3G Option Card
To add a new 3G card, position the monitor with the rear panel facing you and
follow the instructions below.
1.
Place the monitor on a solid, static-free surface and remove the power
cord(s).
2.
Using a small Phillips screwdriver, remove the top cover.
3.
Remove the blank cover plate from the rear panel for the new I/O module’s
slot. Remember to save the four screws for the new rear panel cover plate.
4.
Remove the 3G Option Card from its shipping container being careful to
remain grounded.
5.
When you receive your 3G Option Card, it will arrive partially assembled.
Verify that the external nuts and washers on the gold BNC connectors are
loose.
6.
Insert the 3G Option card into the rear panel opening being careful not to
snag the ribbon cables. Keep them folded against the circuit board to keep
them out of the way.
7.
Insert the card into the slot and press firmly until it plugs in securely.
8.
Insert the rear panel cover screws and tighten.
9.
Replace the lid and the screws.
10. Tighten the external nuts on the gold BNC connectors.
Important
:
Keep the blank cover plate for future use. We recommend taping
it to the side of the monitor; but do not cover the air vent.
