Page 146
APPENDIX A: Dante Network Setup
Introduction
Installing the AMP2-16V into an existing and known functional Dante network is
virtually plug and play. The Dante module rear panel AoIP jack supports 1Gbs and
100Mbs Ethernet devices in Dante Audio over IP network configurations. It can
receive 16 channels of audio from any available sources.
AMP2-16V channel source selections are made by choosing Source Pair Select
‘Dante’ in the Monitor Mixer Configuration Menu as shown in Figure A-1.
Figure A-1: AMP2-16V Source Pair Selection
Monitor Mixer Configuration Menu
Save / Exit
Help
Cancel
Chan 1
Chan 2
Chan 3
Chan 4
Slot 2 Dante
Pair 4
Slot 2 Dante
Pair 5
+0
+0
+0
+0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front
R Front
Center
LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters
Dante Input Module Features
The Audinate Brooklyn II board supports the following features:
DANTE-Compatible Listener
The Dante Input Module for the AMP2-16V offers the following features:
1)
RFC 3551 – RTP Profile for Audio and Video Conferences
a)
L16 16-bit linear format defined in RFC 3551 clause 4.5.11
b)
L24 24-bit linear format defined in RFC 3190 clause 4
c)
AM824 24-bit Audio as defined in IEC61883-6
d)
Multicast and unicast session support
e)
48 kHz audio sampling rate
f)
1 to 8 audio channels per stream
2)
Media clock support
a)
48 kHz and 96 kHz
