Page 44
How do I Show Mixer Output Levels on the Level Meters?
If you have not done so already, you first need to set up a free mix in the output
card. Please refer to How Do I Mix Any Input(s) to Any Output(s)? in this chapter
and set up the needed output mix.
To show mixer output levels, certain configurations must be avoided so that
potential internal feedback loops will not exist within the digital mixer. Output levels
cannot be displayed if:
1.
The monitor mix output pair appears as one of the inputs to the output
mixer, or
2.
The output mixer is in Follow Monitor mode.
Analog I/O Cards with the TOSLINK option will not allow the analog outputs to be
routed back to the monitor mixer to be metered. The internal pathways used for
this feature are also used by the TOSLINK Card.
Output free mix channel pairs will appear as sources in the Monitor Mixer
Configuration Menu:
Configuration Selection
Menu
Main Screen
Menu
Configure
Monitor Mixer
Monitor Mixer
Configuration Menu
Figure 3–23: Monitor Mixer Configuration Menu
Monitor Mixer Configuration Menu
Save / Exit
Help
Cancel
Chan 1
Chan 2
Chan 3
Chan 4
Slot 2 SDI-3G In
Pair 4
Slot 2 SDI-3G In
Pair 5
+0
+0
+0
+0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front
R Front
Center
LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters
1.
Use the Mixer Channel Select to scroll to the channel pair where you want
the output signals to be displayed.
2.
Use the Source Pair Select control to select the output pair to be metered.
