Wohler AMP1-16V-MD, User Manual

Page: 40 / 142

8 2 1 6 9 7 : A M P1 -1 6 V S e r i e s U s e r G u i d e
© 2 0 1 3 Wo h l e r Te c h n o l o g i e s , In c . A l l r i g h t s r e s e r ve d .
32
Ch a p t e r 2 T he “ H o w D o I . . . ” C ha p t e r
F r e q u en t l y A sk e d Q ue s t i o n s
1. Press the Screen Saver button and then turn the Balance knob
to adjust the screen saver timeout or to turn it off.
2. Press the Screen Bright button repeatedly to select which screen
to adjust. The selected adjustment is shown by a blinking
indicator. Turn the
Balance knob to adjust the brightness. The
brightness of each screen will change as you adjust it. The default
level is 22.
Figure 2–17 Hardware Configuration Menu
How Do I Terminate or Unterminate AES Inputs?
AES signals should have one and only one termination. This
termination should physically be located at the last destination of an
AES coax cable. If the AMP1-16V-MD is the last connection in a series
of AES connection, then its terminations should be turned on. By
default, the AES inputs of the AMP1-16V-MD are all terminated.
A symptom of too many terminations (or no termination) is that no
signal appears to be present on the AES input. You can make these
adjustments in the
Hardware Configuration Menu :
Hardware Configuration Menu
AES 75 ohm Term
System Reset
1 2 3 4 5 6 7 8 AES Terminate All
Unit Info
SW Upgrades
-20 dBFS = 0 dBu
Analog Reference
Level
2 hrs Screen Saver
22 22 22
Left Middle Right
Screen
Bright
Configuration Selection
Menu
Main Screen
Menu
Screen Display
Menu
Screen Display Menu
Loudness Menu
Loudness Configuration
Menu
USO
RESTRITO