Wohler AMP1-16V-MD, User Manual

Page: 14 / 142

8 2 1 6 9 7 : A M P1 -1 6 V S e r i e s U s e r G u i d e
© 2 0 1 3 Wo h l e r Te c h n o l o g i e s , In c . A l l r i g h t s r e s e r ve d .
6
Ch a p t e r 1 Q ui c k S t a r t
U s i ng t h e M o n it o r
Hot Keys/Push Buttons: Ten buttons are used for menu navigation
and hot key access to solo, mute, and preset functions.
Back Panel
The AMP1-16V-MD and AMP1-E16V-MD back panel contains all of the
connectors except for the headphone jack as shown in
Figure 1–2
below.
Figure 1–2 Back Panel Layout
• Power: The AMP1-16V-MD and AMP1-E16V-MD use a standard
IEC power cord for the 100 to 240 VAC power connection.
• Ethernet: The Ethernet port is used for system software upgrades.
• Serial: This DB-9F connector is used for system software upgrades.
• Analog Outputs: This DB-25F connector provides eight channels of
balanced analog outputs.The source of these signals is controlled by
the setup menus. (The pin out of this connector is shown in
Table 3–
3 on page 43 .)
• AES Outputs: Each of these two HD-15F connectors supplies four
pairs of unbalanced AES outputs for a total of eight. The source of
these signals is determined by the setup menus. (The pin out of
these connectors is shown in
Table 3–2 on page 42 .)
• AES Inputs: Each of these eight BNC connectors provides an
unbalanced AES input. The monitoring of these signals is
determined by the setup menus.
• 3G/HD/SD-SDI Inputs: These two BNC connectors input two
separate SDI signals. Front panel controls select between the two for
monitoring or down converting.
Power Ethernet Serial GPI/O
AES Outputs
(1 - 4 and 5 - 8)
AES Inputs HD/SD-SDI Inputs
3G/HD/SD-SDI
Re-Clocked Output
Analog Output
USO
RESTRITO