8 2 1 6 9 7 :
A M P1 -1 6 V S e r i e s U s e r G u i d e
© 2 0 1 3 Wo h l e r Te c h no lo g i e s , I n c . A l l r i g h t s r e s e r ved .
119
A p p e nd i x 9
Establishing Connectivity
Co n ne c t i n g D i re c t ly
12.
Once you have a connection to the AMP1-16V, you may begin any
software updates or preset transfers.
13.
If you need to update multiple AMP1-16V units by unplugging
and replugging the crossover cable, be sure to either restart the
computer when changing between AMP1-16V units, or reset the
network interface in the computer between changes.
14.
If you cannot get a connection to the AMP1-16V, close the
Wohler
IP Setup Utility
and wait a few minutes. Open it again, and try the
Search Again
button.
15.
If you still do not see the AMP1-16V, check your system’s network
control panel. Disable any network adapters that you are not
using, such as wireless adapters or other wired adapters. Restart
the computer, and try again. Be sure to re-enable those adapters
when you are finished. An adapter that has a connection to the
internet will take precedence over one that does not (such as the
direct connection between the unit and your computer).
16.
If you still do not see the AMP1-16V, ensure that the network
adapter in the computer you are using is set for DHCP. If it is set
with a static IP, please write it down in the space on the first page,
set it to DHCP, restart the computer, and try again. A static IP
setting will prevent the computer from trying to use AutoIP, and
likely will be a setting that will not allow the computer to
communicate with the AMP1-16V.
17.
If you still do not see the AMP1-16V, please try the instructions
starting with
Setting a Static IP in the AMP1-16V on page 120
Decision Point:
When you have completed the software updates or preset transfers
you wanted, and you are finished,
be sure to restore any settings that
were changed.
After you do that, you are finished with this procedure
and with this document.
If you get a failed or timeout error message, you will need to use one of
the other methods that follow in the next steps. Some computers
simply cannot negotiate the AutoIP protocol in a timely manner.
USO
RESTRITO
Summary of Contents for AMP1-16V-MD
Page 42: ...USO RESTRITO...
Page 54: ...USO RESTRITO...
Page 58: ...USO RESTRITO...
Page 120: ...USO RESTRITO...
