Wintriss wpc 2000, User Manual

Page: 61 / 250

1128500 WPC 2000 User Manual
2-34 Installation
Micro-inch can be wired to be permanently enabled or to be switched on and off.
To wire Micro-inch so that it is permanently enabled, install a jumper between pins #157 and
#155 (Ground) on TB705 on the WPC 2000 Display board (see Figure 2-16 and Table 2-23,
page 2-63).
To wire Micro-inch so that it can be turned on and off, wire a switch to pins #157 and #155 on
TB705 as shown in Table 2-7, below, and Figure 5 at the end of the manual. An optional
Micro-inch On/Off switch is available from Wintriss (see page 1-2).
To set the Micro-inch time, refer to Setting Micro-Inch, page 3-25.
Figure 2-16. WPC 2000 Display Board: Location of Important Components
Table 2-7. Micro-inch Wiring Connections
Display Board TB705
Pin # Signal
157 Micro-inch input
155 Ground
Stroke select
TB 701
Micro-inch/Set auxiliary cams
TB 705
Set cams switch
S701
Operator station select
TB 704
Automatic single-stroke or
Continuous on-demand
TB 703
Mode select
TB 702
Display cable
TB 706
Reset/Select
button/WPC Settings
key switch J 707
LEDs
DS750
DS755
DS749
DS762
DS748
DS760
DS761
DS747
DS759
DS754
DS753
DS752
SET CAMS
NORMAL
Jumper JP 720
(Must be on Run setting)
Monitor
Run
149
148
147
146
151
150
154
153
152
157
156
155
162
161
160
159
158
145
144
143
142
141
WPC Settings key
switch up (+) DS751
Reset/Select
button on DS757
Spare DS756
WPC Settings key
switch down (-) DS758
LEDs
Transmit DS764
Receive DS763
Display cable LEDs