Wintriss wpc 2000, User Manual

Page: 140 / 250

WPC 2000 User Manual 1128500
Initialization, Setup, and Checkout 3-49
The anti-tiedown test verifies that the Operator Station is installed correctly and is wired so
that both hands are needed to press the Run/Inch buttons simultaneously. To perform the test,
do the following:
1.
Set the Stroke Select switch to “SINGLE.”
2.
Press and hold down both Run/Inch palm buttons to cycle the press through one stroke.
When the press top-stops, continue to hold down the left button, and remove your hand
from the right button; then, after a moment, replace your hand on the right button and
continue to hold down both buttons.
•
If the press does not initiate the stroke, go to the next step.
•
If the press does initiate the stroke, check the wiring of the palm buttons. When the
problem has been corrected, repeat step 2. If the press still initiates the stroke, call
Wintriss Tech. Support.
3.
Remove both hands from the Run/Inch buttons.
4.
Press and hold down both Run/Inch buttons to cycle the press through one stroke. When
the press top-stops, continue to hold down the right button, and remove your hand from
the left button; then, after a moment, replace your hand on the left button and continue to
hold down both buttons.
• If the press does not initiate the stroke, the test has been completed successfully. Go to
the next applicable test.
•
If the press does initiate the stroke, check the wiring of the palm buttons, correcting any
problems, then repeat step 4. If the press still initiates the stroke, call Wintriss Tech.
Support.
Anti-repeat Test
The anti-repeat test verifies that the press cycles only once when WPC 2000 is in
Single-stroke mode and both Run/Inch buttons are pressed simultaneously. To perform the
test, do the following:
1.
Set the Stroke Select switch to “SINGLE.”
INJURY DURING TESTING
• Keep all personnel away from the press during testing.
• Be sure there is no die or other tooling in the press during testing.
Failure to comply with these instructions will result in death or serious injury.
OPERATOR STATION MAY NOT MEET SAFETY REQUIREMENTS
Ensure that the Operator Station is wired correctly.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
DANGER
!