Wintriss wpc 2000, User Manual

Page: 172 / 250

WPC 2000 User Manual 1128500
Troubleshooting 5-3
2.
Clear the fault code or message on the WPC 2000 display by doing one of the following:
•
To clear F and H faults, press the Reset/Select button on the display or a Remote Reset
switch if one is installed.
•
To clear E faults, power down the WPC 2000, then power the unit back up
Lockout Message
Certain faults, called Lockout faults, generate the message “Loc” in the LED display after the
fault is cleared. These are serious error conditions and require an additional step. When the
problem has been corrected and the fault cleared, you must turn the Stroke Select switch to
“OFF,” then back to “INCH” or one of the other stroke selections to clear the “Loc” message.
Fault codes that generate the “Loc” message are identified by an asterisk (*) in documentation
of the faults (see E, F, and H Faults, page 5-5).
Brake Monitor Faults
Brake Warning LED
When the Stopping Time of the press increases to within 10 mS of the Stop-time Limit, the
amber Brake Warning LED will flash. Illumination of this LED often means that the brake is
wearing and/or defective. To respond to this error, do the following:
1.
Contact your maintenance crew immediately and have them investigate the condition of
the brake.
Figure 5-2. WPC 2000 Display Showing Lockout Message
Lockout message
BRAKE WARNING
INTERRUPTED STROKE
TOP STOP ANGLE
AUTO CARRYUP
STOP TIME LIMIT
MICRO-INCH
STOPPING TIME
STOPPING ANGLE
90
°
STOP TEST
COUNTER
COUNTER PRESET
ANGLE / SPM
cam on angle
cam off angle