Wintriss wpc 2000, User Manual

Page: 156 / 250

WPC 2000 User Manual 1128500
Operation 4-7
2.
Adjust the current counter preset by turning the WPC Settings key switch to “+”
(counterclockwise) to increase the setting or to “–” (clockwise) to decrease the setting.
Disabling the Counter Preset
You can disable the counter preset feature by forcing the counter preset value to zero (0).
Disabling the counter preset has no effect on the counter itself, which will still maintain a
cumulative total of press strokes. However, since there is no preset value, WPC 2000 will not
stop the press. The counter continues to increment up to the value 999999, then rolls over to
zero, and starts counting again at one (1).
To disable the counter preset, do the following:
1.
With the “Counter Preset” segment illuminated and the current counter preset value
displayed, turn the WPC Settings key switch to “–” (clockwise) and hold it while you
press the Reset/Select button. The LED display will show the value 0 (zero).
2.
Release the WPC Settings key switch.
Figure 4-3. WPC 2000 Display with “Counter Preset” Value Shown
The longer you turn (and hold) the key switch to “+” or “–”, the more quickly the value
changes.
If the number you want to enter is very large (500,000 to 999,999), force the display to
999,999 (see Forcing the Counter Preset Value to 999999, page 4-8). Then turn the
Settings key switch to “–” and hold it there to decrease the displayed value until it reaches
the value you want.
BRAKE WARNING
INTERRUPTED STROKE
TOP STOP ANGLE
AUTO CARRYUP
STOP TIME LIMIT
MICRO-INCH
STOPPING TIME
STOPPING ANGLE
90
°
STOP TEST
COUNTER
COUNTER PRESET
ANGLE / SPM
cam on angle
cam off angle
To set the counter preset, press the Reset/Select button
until the “Counter Preset” segment is lit, then turn the
WPC Settings key switch to “+” to increase the setting
or to “-” to decrease the setting.
NOTICE
NOTICE