Wintriss wpc 2000, User Manual

Page: 157 / 250

1128500 WPC 2000 User Manual
4-8 Operation
Forcing the Counter Preset Value to 999999
If the counter preset value you want to enter is very large (i.e, 500,000 or higher), you may
want to force the preset to its upper limit, 999999, then decrement the preset until the value
you want is displayed. To force the counter preset to 999999, do the following:
1.
Force the counter preset value in the LED display to zero (0) as described in the previous
section.
2.
Turn the WPC Settings key switch to “–” (clockwise) again and release the key
immediately. The LED display will show the value “999999.”
Operating the Press in Inch Mode
To operate the press in Inch mode, do the following:
1.
Set the Stroke Select switch to “INCH.”
2.
Set the Mode Select switch as follows:
If a light curtain is installed on the press, set the switch to “2 HAND” or “1 HAND.” The
light curtain will be muted on the upstroke if WPC 2000 has the muting option.
If no light curtain is installed, set the switch to “2 HAND.” If you set the switch to
“1 HAND,” WPC 2000 defaults to Two-hand mode.
IMPROPER SAFEGUARDING
Ensure that the machine guarding system is installed and maintained according to OSHA
regulation 1910.217, ANSI standards B11.1 and B11.19, and any other regulations or standards
that apply. Ensure that guarding is properly installed to prevent access to the machine over, under
or around any guarding device.
Failure to comply with these instructions will result in death or serious injury.
INCH MODE NOT SUITABLE FOR PRODUCTION
DO NOT use INCH mode as a production mode, per ANSI B11.1-2009.
Failure to comply with these instructions will result in death or serious injury.
ESTOP/INTERRUPTED STROKE WHEN IN INCH MODE
If the press is in Inch mode when it is Emergency-stopped, it does not switch to Two-hand
Maintained Single-stroke but stays in Inch for the remainder of the stroke.
DANGER
!
DANGER
!
NOTICE