P a g e
|
40
d.
The AUTO PEAK screen asks if you would like to turn on AUTO PEAKING. If Auto
Peaking has not been turned on before, then the default is from the factory.
Auto Peaking is available on all selections except for HughesNet and Generic,
and is at the discretion of the installer.
Select “Yes” here.
e.
After selecting “Yes” at the AUTO PEAK screen, you will get the following screen
which allows you to CHANGE Peaking values, STOP the auto peaking process or
continue without changes by pressing “OK”.
Remember that AUTO PEAKING was originally disabled and pressing YES on the
previous screen enabled it so the “OK” button here merely continues with the
configuration with Auto Peaking enabled.
NOTE: AUTO PEAK DOES NOT TURN OFF THE TRANSMITTER.
The goal of Auto Peaking is to examine the SNR changes over time and adjust the
antenna pointing to ensure optimal signal at all times.
Because we do not want to take the system offline to peak the antenna, the
peaking values allow you to set maximum movement of the antenna, maximum
speeds and maximum current therefore keeping the peaking process within a
window that will not adversely affect adjacent satellites.
Summary of Contents for 2-WAY SATELLITE INTERNET SYSTEM
Page 10: ...P a g e 10 3 Open lids on both sides as shown below ...
Page 19: ...P a g e 19 ...
Page 56: ...P a g e 56 ...
Page 81: ...P a g e 81 9 4 Wiring Diagram User Supplied Device ...
