Wincor Nixdorf TH180, Programmer'S Manual

Page: 92 / 162

TH180 Programmer’s Guide
87
Command related to paper detectors
ESC c 3 n
[Designation] Select paper sensor(s) to output paper out signals
[Format] 1BH, 63H, 33H, n
[Valid limits] 0 n 255
[Initial value] n = 0
[Function] (1) Selects the paper detectors to output the paper out signal when paper out status
occurs.
(2) The table below lists the bit definitions.
Bit Function
Value
0 1
0 Roll paper near end detector Disable Enable
1 Roll paper near end detector Disable Enable
2 Roll paper end detector Disable Enable
3 Roll paper end detector Disable Enable
4 To be defined --- ---
5 To be defined --- ---
6 To be defined --- ---
7 To be defined --- ---
(3) Multiple paper detectors can be selected at the same time.
When multiple paper detectors are enabled, the paper out signal is output
when any one of the paper detectors detects paper out.
(4) This command is valid for USB(PRINTER) specifications.
This command is ignored for serial interface and USB(V-COM) specifications.
(5) Executing this command switches the detectors. As a result, Command
reception and paper out signal switching can be delayed depending on the
receive buffer status.
(6) If bit 0 or 1 is 1, the roll paper near end detector is selected as the paper
detector.
(7) If bit 2 or 3 is 1, the roll paper end detector is selected as the paper detector.