Wincor Nixdorf TH180, Programmer'S Manual

Page: 124 / 162

TH180 Programmer’s Guide
119
GS ( E pL pH fn
[
parameter
]
[Designation] User setting command group
[Function] (1) The command in the user setting command group is used to control the values that are
stored in the non-volatile memory. It also executes the functions that are designated by the
function code (fn).
fn Function No. Function
1 Function 1 Moves to the user setting mode
2 Function 2 Finishes the user setting mode
3 Function 3 Sets the value of the memory switch
4 Function 4 Transmits the value of the memory switch
5 Function 5 Sets the customized value
6 Function 6 Transits the customized value
7 Function 7 Copies the user definition page
8 Function 8 Defines data according to the column format to the character
code page in the operation area
9 Function 9 Defines data according to the raster format to the character
code page in the operation area
10 Function 10 Deletes data of the character code page in the operation area
11 Function 11 Sets the communication conditions of the serial interface
12 Function 12 Transmits the communication conditions of the serial interface
pL, pH is m and it designates the subsequent byte value as (pL+pHx256).
(2) Software reset is executed by Function 2. The receive buffer and print buffer clears and various
settings (download character, macro, character decoration, etc.) return to the state when power
goes on.
(3) The stored value can be confirmed by functions 4, 6, 12 of this command without moving to the
user setting mode.
(4) Using this command often may cause destruction of the non-volatile memory.
Use this command that writes data to the non-volatile memory less than 10 times per day.