Wincor Nixdorf TH180, Programmer'S Manual

Page: 108 / 162

TH180 Programmer’s Guide
103
Command related to the panel switches
ESC c 5 n
[Designation] Enable/disable panel buttons
[Format] 1BH, 63H, 35H, n
[Valid limits] 0 n 255
[Initial value] n = 0
[Function] (1) Enables/disables the paper feed switch.
(2) Each bit of parameter n is defined as listed below:
Bit Function
Value
0 1
0 Panel switch Enabled Disabled
1 To be defined --- ---
2 To be defined --- ---
3 To be defined --- ---
4 To be defined --- ---
5 To be defined --- ---
6 To be defined --- ---
7 To be defined --- ---
(3) Only the lowest-order bit of parameter n is valid.
(4) If the panel switch is disabled, all panel switches will be disabled.
(5) For this printer, the panel switch means the paper feed switch.
(6) At switch standby when the macro is executed, the paper feed switch is enabled
regardless of the setting of this command. However, the paper is not advanced.
(7) Even if this command enables the panel switch, the switch will be disabled in
the following cases:
a. There is no paper in the roll paper end detector.
b. The cover is open.