Wincor Nixdorf TH180, Programmer'S Manual

Page: 90 / 162

TH180 Programmer’s Guide
85
GS V m n
[Designation] Cut paper (No. 2)
[Format] 1DH, 56H, m, n
[Valid limits] m = 65,66
0 n 255
[Initial value] ---
[Function] (1) Performs a cut operation of a specified type.
m Function
65 Not specified
66
Advance the paper (cut po [n×basic calculated pitch]) and
partially cut the paper (one point center uncut).
(2) This command is valid only when entered at the beginning of a line.
(3) If n = 0, the paper is cut off after it is advanced to the specified position.
(4) If n 0, the paper is cut off after it is advanced further through "n×basic
calculated pitch" from a specified cut position.
(5) The basic calculated pitch is set up using the Set the basic calculated pitch
command (GS P).
(6) The paper feed amount is calculated using the vertical basic calculated pitch (y).
If the calculation result contains a fraction, the value is corrected using the
minimum pitch of the mechanism. The remainder is then discarded.
(7) In page mode, this command cuts the paper at once.