Wincor Nixdorf TH180, Programmer'S Manual

Page: 138 / 162

TH180 Programmer’s Guide
133
<Function 11> GS ( E pL pH fn a d1…d k
[Format] 1DH, 28H, 45H, pL, pH, fn, a , d1…dk
[Valid limits] 3 (pL+pH×256) 65535 (0 pL 255, 0 pH 255)
fn=11
1 a 4
48 d 57
1 k 6
[Initial value] Initial value of a=1: (d1…dk)="115200"
Initial value of a=2: d1=48
Initial value of a=3: d1=48
Initial value of a=4: d1=56
[Function] (1) a sets the designated serial interface communication conditions to d.
a Communication conditions d specification
1 Baud rate K byte of (d1…dk)
2 Parity 1 byte of (d1)
3 Flow control 1 byte of (d1)
4 Data length 1 byte of (d1)
(d1…dk) changes to the setting of the baud rate. The baud rate that is possible for definition is shown as
below:
Baud
rate
d1 d2 d3 d4 d5 d6
2400 50 52 48 48 - -
4800 52 56 48 48 - -
9600 57 54 48 48 - -
19200 49 57 50 48 48 -
38400 51 56 52 48 48 -
57600 53 55 54 48 48 -
115200 49 49 53 50 48 48
d1 changes the designated parity.
d1 Parity setting
48 Without parity
49 Odd number parity
50 Even number parity
d1 changes the designated flow control setting.
d1 Flow control setting
48 DSR/DTR control
49 XON/XOFF control
d1 changes the data length setting.
d1 Data length setting
55 7 bit long
56 8 bit long
(2) This command ignores the invalid value that designated by a, d1. (No changes to the setting)
(3) This function activates only in the user setting mode.
(4) The non-parity of 7 bit long data is not supported.
The designation becomes invalid.
The following designated order becomes invalid:
a. 8 bit / during non-parity setting, designate 7 bit
b. 7 bit / during odd- or even-number parity setting, designate non-parity