Wincor Nixdorf TH180, Programmer'S Manual

Page: 103 / 162

TH180 Programmer’s Guide
98
Status Parameter
Status bit
Remark
b7 b6 b5 b4 b3 B2 b1 b0
Print head
temperature
high
First byte 0 × × 1 1 × 0 0 Paper feed by paper feed
switch, cover state, and state
of the drawer kick connector
pin 3 may be superimposed.
Second Byte 0 1 × 0 0 × × × Unrecoverable may be
superimposed.
Third Byte 0 0 0 0 × × × × The roll paper end and roll
paper near end detectors may be
superimposed.
Fourth Byte 0 0
×
0 1 1 1 1 F/W down load Fail
Unrecoverable
error detected
Abnormal
voltage
Watchdog timer
error
ROM/RAM
error
No print
First byte 0 × × 1 1 × 0 0 Paper feed by paper feed
switch, cover state, and state
of the drawer kick connector
pin 3 may be superimposed.
Second byte 0 × 1 0 0 × × × Auto-recoverable errors may be
superimposed.
Third byte 0 0 0 0 × × × × The roll paper end and roll
paper near end detectors may be
superimposed.
Fourth byte 0 0 × 0 1 1 1 1 F/W down load Fail
Cutter jam
Error First byte 0 0 × 1 1 × 0 0
Cover state, and state
of the drawer kick connector
pin 3 may be superimposed.
Second byte 0 × 0 0 1 1 × × Unrecoverable may be
superimposed.
Second byte 0 0 0 0 × × × ×
The roll paper end and roll
paper near end detectors may be
superimposed.
Fourth byte 0 0 × 0 1 1 1 1 F/W down load Fail
* When cover open,
(1)Not printing
bit3 and bit5 of first byte change, but bit2,6 of second byte not change.
(2)Printing
bit3 and bit5 of first byte change
When set “COVER OPEN ERROR:AUTO RECOVERY”:
bit6=1,bit2=0(second byte)
When set “COVER OPEN ERROR:RECOVERY BY CMND”:
bit6=0,bit2=1(second byte)
(9) If the Real-time status transmission command (DLE EOT), Transmit printer ID
command (GS I), and Transmit status command (GS r) are used, the states of
these commands and the ASB status must be identified.
(10) A delay may occur between command reception and status transmission
depending on the condition of the reception buffer because this command is
executed during print buffer expansion.