Wincor Nixdorf TH180, Programmer'S Manual

Page: 105 / 162

TH180 Programmer’s Guide
100
b. When n = 2, 50 (drawer kick connector)
Bit Function
Value
0 1
0 State of drawer1 kick connector pin 3 Low High
1 To be defined --- ---
2 State of drawer2 kick connector pin 1 Fixed at 1(High)
3 To be defined --- ---
4 Not used Fixed at 0
5 To be defined --- ---
6 To be defined --- ---
7 Not used Fixed at 0
(3) Roll paper end detector (n=1,49) is paper present (b3 = 0, b2 = 0) when the
cover is open.
(4) After the mechanics operation ends, status is transmitted.
(5) After the host is confirmed to be ready to receive status information, this
information is transmitted to the host if the DTR/DSR protocol is used. If the
host is not ready to receive, transmission of the status information is deferred
until the host is ready.
(6) If the XON/XOFF protocol is used, status information is transmitted to the host
without checking whether the host is ready to receive.
(7) A delay may occur between command reception and status transmission
depending on the condition of the reception buffer because this command is
executed during print buffer expansion.
(8) The status of this command and the ASB status must be identified.