Will Burt NIGHT SCAN VERTICAL, Operating Instructions Manual

Page: 99 / 100

PAGE 97 OF 98
NIGHT SCAN VERTICAL
OPERATING INSTRUCTIONS
TP-4836201-G
MARCH 2021
GRN VIO GRY VIO
(init)
WHT BLK RED
BLK
(kill) (com)
PANEL MOUNT
REMOTE CONTROL
KILL
INITIATE
BRN BLU RED 10 GA BLK 10 GA
2
8
TO BASE BOARD - SEE SYSTEM WIRING DIAGRAM INTERCONNECT CABLES
A. DC & CONTROL CABLE,
WITH
CONNECTOR
OR B. DC & CONTROL CABLE,
WITHOUT
CONNECTOR
OR C. CONTROL CABLE
ONLY
(DOES
INCLUDE 10 GA
RED & BLACK, 18 GA RED & BLACK
TWISTED PAIR)
GRN/YEL
7
BLK
WHT
BLK
RED
GRY
VIO
GRN (init)
(com)
(kill)
J4 ON BASE BOARD
JUMPER FROM 5-7 REQUIRED FOR STANDARD (NON-NFPA) OPERATION
4
5
2
CONNECT SHIELD GROUND TO J4-2 (N/A ON CABLE "A")
VIO
CONNECT SHIELD GROUND TO PIN 2 IF USING CABLE "A".
PMRC
915377
4858701
4858703 4858702 4858704
4 3
3
KITS
4735002 4735021 4735022 4756921 4756922
4
CUSTOMER SUPPLIED
NOT USED ON 915377
FACEPLATE
C
C
DJB
JDN

NOTES
1. TORQUE: 4.4in-lbs, 0.5Nm
2. "MAST ACTIVE" CONTACTS, J-K OR J4 9,10: USE SW2-1 ON BASE BOARD TO SELECT OPEN (OFF) OR CLOSED (ON) WHEN NESTED.
SW2-1 OPEN = CONTACTS CLOSED WHEN NESTED SW2-1 CLOSED = CONTACTS OPEN WHEN NESTED. 2 AMPS MAX CURRENT, 20 GA. MINIMUM CONDUCTOR. CUSTOMER SUPPLIED WIRING.
3. SW2-2 ON BASE BOARD MUST BE OPEN (OFF) FOR NFPA MODE.
4. SW2-2 ON BASE BOARD MUST BE CLOSED (ON) STANDARD MODE.
5. REMOVE JUMPER(S) IF REPLACED BY PARKING BRAKE INTERLOCK. G-H CLOSED WHEN BRAKE "ON".
AVAILABLE IN STANDARD MODE ONLY.
6. 4521802 CABLE: ALL WIRES 20 GA. EXCEPT RED AND BLACK (J4-1 AND 2).
7. OPTIONAL DISABLE INPUT, CUSTOMER SUPPLIED CONTACTS. MUST HAVE CONTINUITY TO FUNCTION. WILL
NOT ALLOW OPERATION IF OPEN, ACTS AS EMERGENCY STOP
8. BATTERY CONNECTION TO SYSTEM: IN-LINE SPLICE RECOMMENDED. DO NOT USE TERMINALS E & F. 9. 18 GA. MIN. IF USING 4521802 SIGNAL CABLE TO BASE BOARD WITH SEPARATE 10GA TO BASE BOARD.
nightscan
UNIVERSAL CONTROL
SINGLE HARD-WIRED
PANEL MOUNT REMOTE CONTROL
™
NSU J-Box Wiring3.dwg
BY/APPVL
DJB/JMK DJB/JMK DJB/JLK DJB/AW