Will Burt NIGHT SCAN VERTICAL, Operating Instructions Manual

Page: 28 / 100

PAGE 26 OF 98
NIGHT SCAN VERTICAL
OPERATING INSTRUCTIONS
TP-4836201-G
MARCH 2021
5. The installed elevation of the bottom collar of the mast (this is where moving parts are
located) must be at least 2.7 meters (8.8 feet) above ground level to prevent reach of upper
extremities during operation. Alternatively, lower elevations are permitted if the mast is
properly guarded by the installer, or if the mast is offset towards the middle of the roof with
reach limited by vehicle structure to prevent contact with the mast during operation.
5.1.1 Dimensions
Refer to the drawings that ship with the mast for detailed information on the size of the system.
Additional room may be required for optional components such as a camera, strobe light, or D-
TEC Power Line Detection System.
5.2 Recommended Installation Tools
Table 5-2 lists recommended tools and materials for installation.
5.3 Unpacking & Handling
Unpack and handle the items as follows:
1. Carefully remove all the small cartons from the large crate or carton.
2. Remove all the items from the small cartons.
3. Ensure all components are included and that the required tools are readily available. The
components in the system shipment are shown in Table 5-3.
Table 5-2 Recommended Installation Tools & Materials
Tools and Materials
Safety Glasses Safety Gloves Safety Shoes
Hard Hat or Helmet Hearing Protection Crimping Tool or Solder Set
Wrenches Screwdrivers Multimeter (to verify power is turned off)
Torque Wrench Drill Knife or Scissors to Cut Crate Band
Wire Cutter/Stripper RTV Silicone 3/8 inch or M10 Mounting Hardware (10 each)
Shop Rags Hoist (minimum 500 lb. (227 kg) capacity)
Note: Depending on the national and local standards and codes of practice, and the
environment, additional personal protective equipment may be necessary.
Table 5-3 Components in Night Scan Vertical System Ship
Mast
Mounting Kit (Internal
or External)
Base Plate Saddle Kit