Will Burt NIGHT SCAN VERTICAL, Operating Instructions Manual

Page: 19 / 100

PAGE 17 OF 98
NIGHT SCAN VERTICAL
OPERATING INSTRUCTIONS
TP-4836201-G
MARCH 2021
Figure 3-2 Night Scan Vertical Stowed View
Mast: The mast consists of concentric tube sections that extend as air pressure is applied. The
mast contains a coiled cord in the center for power and data. Optionally, an external Nycoil® may
be included (not shown) for camera or other accessory cables. The bottom of the mast typically
connects to the base plate. The bottom of the mast also connects to the air source. The top of the
mast connects to the Remote-Controlled Positioner (RCP). Each tube and collar is protected by
low friction synthetic bearings for smooth operation and long life. Bumpers reduce shock on
extension and retraction. The exterior surfaces of the tubes are anodized and sealed for long life.
The fasteners are corrosion-resistant stainless steel.
The mast (Figure 3-3) contains:
• Tube sections
• Internal coil cord
Figure 3-3 Mast Components
Mounting Hardware: Your system may come with either internal or external mounting hardware.
Internal: The internal mounting kit (Figure 3-4) contains the brackets and seals used to position
and support an internally mounted mast. The kit includes a two-piece bracket, sealing gasket,
wear ring, and V-Seal. Bolts, lock washers and hex nuts, 1/4 inch or M6, not provided, can be
Optional Camera or Strobe Location
Light Bar
Mast
Lights
RCP
RCP Saddle
Look-Up Light (top of RCP)
Data and Light Power Plugs
Internal Coil Cord
Tube Section Collars