Will Burt NIGHT SCAN VERTICAL, Operating Instructions Manual

Page: 42 / 100

PAGE 40 OF 98
NIGHT SCAN VERTICAL
OPERATING INSTRUCTIONS
TP-4836201-G
MARCH 2021
Figure 5-13 RCP Installation
5.8 Installing the Magnetic Switches
Note: The magnetic switches contain Reed switches made from glass tubes that can be
damaged under high impact loading due to handling. This requires the installer to be careful
when handing the switches.
The magnetic switches interact with a permanent magnet installed at the bottom of the mast top
tube (not visible). When the magnet is in proximity to the switch, the switch is triggered. For
internal mounting applications, be sure to install the mast in the internal mounting kit in the
vehicle before installing magnetic switches so the mast will fit through the opening in the roof.
The magnetic switches are shipped loose with the mast. The upper magnetic switch defines the
trigger point to make the RCP functions active. The goal is to have this trigger point high enough
to clear all vehicle obstructions before panning or tilting the lights. First, install the upper
magnetic switch at the top of the mast per Figure 5-14. This should be located within 12 mm (1/2
inch) from the bottom of the base tube collar as a starting point. This height can be adjusted later.
Tighten the band clamp in the desired position. Note the orientation of the switch on the tube
diameter must match Figure 5-14 because the magnet is installed to one side of the mast top
tube. Note the orientation of the cable entry and pneumatic port at the bottom of the mast to
position both the top and bottom switch orientation.
Attach the bottom switch toward the bottom of the mast, again noting the proper orientation
shown in Figure 5-14. The final height of this switch will be adjusted after the control systems are
RCP Installation
Screws