Wayne Ovation, Installation & Operation Manual

Page: 8 / 88

2
Part No. 920559 Rev H November 2008
1.2 Local, State, and Federal Codes
All tanks (both underground and above ground), piping and fittings, foot valves, leak detectors, cor-
rosion protection devices, wiring, venting systems, etc., must be installed in accordance with the
manufacturer’s instructions and in compliance with local and regional building codes and require-
ments pertaining to service stations (or other locations where the dispenser may be installed).
These requirements may include references to the National Electrical Code (NFPA 70), Automotive
and Marine Service Station Code (NFPA 30A); Flammable and Combustible Liquids Code (NFPA
30); Code of Federal Regulations, Title 40, Section 280 (40 CFR 280); United States Environmental
Protection Agency (U.S. EPA) Technical Regulations of 9-23-88 and U.S. EPA Financial Responsibil-
ity Regulations of 10-26-1988.
Where local requirements do not specify applicable codes, Wayne recommends using the codes
listed above. These codes are comprehensive and detailed, often requiring interpretation to cover
unusual situations, and, therefore, the associated handbooks (where applicable) should also be con-
sulted. (The handbooks are also available from the same sources.)
Due to the variety of locations encountered, further information on installation cannot be dealt with
in this document except as the codes relate directly to the installation of the dispenser. Therefore, it
is strongly recommended that
a qualified engineer or contractor familiar with local regulations
and practices be consulted before starting installation.
Sources for various codes are listed on the following page.