6 - 2
Watkiss Automatic SpineMaster Service Manual - Edited 17/06/04
General Procedures
•
Product Specifications
6.1 Product Specifications
Intended Use
This product is intended for the re-forming of booklet
spines, to flatten the booklet and give a square appearance
to the spine, within the specifications below.
Production
up to 1400 per hour single pass
Booklet Size
from 80 x 120mm to 250 x 350mm
(dependant on specification of connected equipment)
Booklet Thickness
minimum of 1mm, 0.04”
maximum of 6.5mm, 0.25”. This is approximately 30
sheets of 80gsm (20# bond) folded into a 120 page book-
let.
Dimensions
Width
Depth
Height
Weight
707, 28”
690-762mm, 27-30” (dependant on version)
1138-1178mm, 45-46½” (dependant on version)
132kg, 291lb
Electrical
230V, 50Hz, 3A or 115V, 60Hz, 5A
Single Phase, Earthed supply required
Noise
72 dB(A)
Operating Conditions
10-35°C at 35-85% relative humidity
Production and specifications are subject to operating conditions. The specified
paper thickness figures are given for guidance only. The actual performance of the
machine will depend on the nature of the paper and covers used. In line with a policy
of continual improvement, the manufacturer reserves the right to alter the materials
or specifications of this product at any time without notice.
Radio Frequency Emissions
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interfer-
ence in which case the user will be required to correct the interference at his own
expense.
