Installation Procedures
•
Installing the ASM onto a Nagel Trimmer
Watkiss Automatic SpineMaster Service Manual - Edited 17/06/04
8 - 21
9.
Locate the terminal block on the PCB. Remove the
existing brown wire from position 10 and fit to one side
of the new terminal block.
10. Fit the new green wire to the other side of the new termi-
nal block.
11. Fit the black wire to position 10 on the Nagel terminal
block.
Observe the routing for the wires, as shown in the photo-
graph. Use the cable tie pads to secure the wires.
12. Refit the cover on the electrical compartment and refit
the two side covers.
13. Fit the joint plate onto the Trimmer.
14. Adjust the height of the ASM to ensure that a good paper
path is achieved between the two units. To set the
height, adjust the 4 jacking screws attached to the base
wheels using a 14mm spanner.
Brown
(existing)
Green (new)
10 11 12
Black (new)
Black (existing)
White (existing)