Waters Xevo TQD, Operator'S, Overview And Maintenance Manual

Page: 227 / 250

Connecting the workstation B-19
Connecting the workstation
Before connecting the workstation to the instrument, set up the workstation
according to its accompanying instructions. Locate the workstation within
5 meters (16 feet) of the instrument.
Requirement:
Use shielded network cables with the instrument to ensure
compliance with FCC, and other, limits.
To connect the workstation:
1. Connect the monitor to the PC.
2. Connect one end of the shielded network cable to the appropriate port on
the rear panel of the instrument.
3. Connect the other end of the shielded network cable to the port labeled
Instrument LAN on the workstation rear panel.
To connect the instrument to the power source:
1. Select the correct power cord for your location.
2. Connect the female end of the power cord to the power port on the rear
panel of the instrument.
Connecting Ethernet cables
Requirement:
Use shielded Ethernet cables with the instrument to ensure
compliance with FCC, and other, limits.
To make Ethernet connections:
1. Connect one end of one shielded Ethernet cable to the network switch,
and then connect the other end to the Ethernet card on the
preconfigured ACQUITY™ workstation.
Tip:
On preconfigured systems, the Ethernet card is identified as the
Instrument LAN card.
Caution:
Do not connect the instrument’s power supply cord until you
complete the installation procedures in the previous sections.