Vodavi Starplus STSe, Quick Start Manual

Page: 8 / 72

STSe Quick Start Guide September 2005
- 4 -
VO D AVI
NOTE
: To the left of the battery is the PMU card. At the bottom of the PMU card is a switch marked:
1 (UP), 2 (Down). When new software (s/w) is uploaded, the new s/w is located opposite of the
position of the switch. Thus, after uploading new s/w, placing the switch in the opposite position the
system will utilize the new s/w. Placing the switch back would change the system back to old s/w. See
“Software Upgrade” for procedures to upload software.
12. Turn power ON. Let the phones power up and display is normal. Turn power OFF and wait a few
seconds. (It is important that this procedure is not rushed). Turn power back ON and then place Dip
Switch 8 OFF on the Orange Switch (SW5). System is now defaulted and ready to program. With Dip
Switch 8 Off on SW5, system will now retain program memory).
PROGRAMMING
13. At Station 100, enter programming: * * 3226
14. Flex Buttons are as follows: Top row left button is “Flex Button 1” and to the right are
“Flexible Buttons 2, 3, and 4”. The second row is Flexible Buttons 5 through 8 and etc.,
through “Flexible Button 24”.
15. Press FLASH button and dial 24 (Card Slot Programming).
16. Flexible Button 1 is Card Slot “0”; Flex Button 2 is Slot 1 and so forth. Card Slots 0, 1, 2 are built-in
(4x8x2). Flex Button 4 is Card Slot 3. Program Card Slots 3 through 13 as required.
Enter the valid number for the type of card plugged into the current card slot, then Press “ HOLD ”.
[00]= None [13] = SL04 (SLIB w/4 ports]
[02]= DTIB [15] = LCI4 (LCOBC)
[04]= SL02 (SLIB w/2ports) [17] = VMD1 (flash-based VMIB)
[09]= T1IB (see below) [17] = VMD2 (hard drive-based VMIB)
If the T1IB option is selected, enter a valid number (1-5) to specify the desired cluster (partial) quantity.
[1]= Cluster 4 [4] = Cluster 16
[2]= Cluster 8 [5] = Cluster 20
[3]= Cluster 12 [No Entry] = All CO lines (24)
Press HOLD to save entry. A confirmation tone sounds and the display updates. When finished, the
system must be reset for these changes to take effect. Only FLASH 24 requires system to be reset.
NOTE
: T1IB is not applicable with the STSe Residential KSU System.
17. A normal programming setup is as follows:
Several stations ring on incoming CO and if not answered, the Auto Attendant will answer. When a call
is transferred to a person’s phone, if they do not answer, the call goes to that person’s voicemail box to
leave a message. Below are the steps to accomplish this function. (See Programming Manual section
“F”, Flash Codes and Flex Button Codes, or Feature Codes for page reference.)
a. * * 3226
b. FLASH 40
c. Enter COs to be programmed and press HOLD, or press HOLD to program all CO lines.
d. Display shows “CO Programming” and the range of lines that are being programmed plus
“Page A”.
e. Press Flexible Button 13. This displays the stations that are assigned to ring on those CO
lines. The default display shows S100
A (Station 100 rings A ll the time).