Vodavi Starplus STSe, Quick Start Manual

Page: 48 / 72

STSe Quick Start Guide September 2005
- 44 -
VO D AVI
WIN DBA (cont’d)
Review Programming Sections in the WIN DBA Software:
1. Select “Account Codes”. (See Programming Manual, Section F, Flash 05 Flex Button 8; Flash 06 Flex
Button 3; Flash 31 for programming information.)
a.
Enter Account code, Day and Night COS.
b. Click either Verified or Forced and the will take you to System feature codes. Click (check) either
Verified, Forced or Both. Click Save and the “X” block to exit.
c. Complete Account codes if needed. (Not a normal item to use on the average STSe system.)
d. Select “Cards”. (See Programming Manual, Section F, Flash 24 for programming information.)
NOTE
: Slot 0 and 1 are fixed. Slot 2 should be also, since this is the 2 port analog card. To add a card
to a slot; first click on slot ( NOTE : The Block “Card Type” will indicate what that card slot is
programmed for). Use the Arrow down icon to find the card name to select and click on name. Card
name is now in the Card Type block. Click on that card slot again. Now the card is identified for that
card slot. Continue until all card slots are programmed as required.
NOTE
: Remember when program is up loaded that the system must be reset for Card Slot
programming to take effect.
e. Click the “X” block to save and exit this section.
2. Select “CO Lines”. (See Programming Manual, Section F, Flash 40 for programming information)
a. Note you are on CO # 1. By clicking on the > < buttons you can move from one CO to another.
b. Note the folders (CO, Timers, Features, Ring Assign, Grid, Copy, and Report).
c. Program each CO as required.
d. Note the copy folder you can copy blocks of CO Lines in three groups and also ringing assignments
either “Yes or No”.
e. When complete, click Save then “X “to exit.
3. Select “DID”. (See Programming Manual, Section F, Flash 43 & Flash 44 for programming information)
a. Program as required
b. When complete Click Save and “X” to exit.
4. Select “Hunt Groups”. (See Programming Manual, Section F, Flash 30 for programming information.)
a. Note: Three types of hunt in, Group Type.
b. Enter members (station numbers) up to 8 maximum.
c. When complete, save and click on “X” to exit.
5. Select “LCR Programming”. (See Programming Manual, Section F, Flash 75, Flash 50 Flex Button 9, Flash
05 Flex Button 7 for programming information.)
a. Program as required.
b. When completed, save and click on “X” to exit.
6. Select “Passwords”. This is the password for WINDBA. Note there is no back door password if you
change it, so
DO NOT loose password.